|
S-Yard Cleancut Razor Maintenance
The S-Yard Cleancut shaver has a precision blade and foil combination. This blade and foil set come into direct contact with each other when in use. Like with any mechanical items that have metal on metal contact, lubrication needs to be used to prevent premature wear and tear. To prevent this, oil your shaver using clipper/shaver oil after every 1-2 uses. Simply place 1 drop on the inside of the shaving foil after cleaning. Replace blade and foil and turn the unit on to distribute the oil evenly. Now it is ready for the next use.
The blades on the S-Yard Cleancut are adjustable so you dont need to buy new blades all the time. This saves you money. When the S-Yard cleancut is used on a regular basis about every 8-12 months you may need to make an adjustment to the blades. Here is how you do it.
- Unscrew the shaving foil
on the S-Yard Cleancut
- Remove blades. Use caution as blades may be sharp
- Between the 3 blades there is a small screw.
- Using an eyeglass screwdriver turn this screw 1/8 of a turn CLOCKWISE
- Clean shaver and blades
- Oil Foil (instructions above)
- Replace blades
- replace foil
- When twisting foil into place look to make sure the blades move during the last full turn of the shaving foil.
- If blades do not turn when foil is twisted on repeat above directions.
- Do not over tighten as this will cause damage to the unit.
- Do not tighten more than 2 times (1/4 turn total). Contact us if you need to at this point.
If the blades turn this shows good contact.
|